Installing opnsense9/13/2023 ![]() Replace with your ipv6 and ipv4 networks as applicable. ![]() Server-key = /usr/local/etc/ocserv/server-key.pem WARNING: Even if you define a cert and root you still need to define them in the config!* server-cert=/usr/local/etc/ocserv/server-cert.pem This assumes you're using a certificate, if not you should be fine to leave the first to (Server and Root) set to none and you can leave out the following three lines from the config box: ![]() Once installed then you can setup OCServ from the GUI. Now you can go in the GUI and go to System > Firmware > Plugins and find ocserv and install (it may "hang" for a couple minutes, just wait) To start login to OPNSense and become root then paste in:įetch -o /usr/local/etc/pkg/repos/nf It was an adventure so here is a guide to getting going. This was an adventure for sure so I figured a guide was in order for anyone else looking to setup openconnect (ocserv) server on OPNSense.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |